Deleting a product group, Port groups – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 226
Brocade Network Advisor SAN + IP User Manual
159
53-1002949-01
Port Groups
5
4. Click OK to close the dialog box.
Deleting a product group
You can delete more than one group at a time.
NOTE
You cannot delete a system group.
To delete a product group, complete the following steps.
1. Select Network Objects from the view list on the Product List toolbar.
2. Right-click the product group you want to delete in the Product List and select Delete Group.
Ctrl and click to select more than one group to delete.
A confirmation message displays.
3. Click Yes.
The group is deleted from the User-Defined Groups folder of the Product list.
Port Groups
Port groups allow you to group ports together across network devices to perform common
port-based configuration and monitoring activities.
Once configured you can use port groups to perform the following:
•
Deploy common configurations to all ports in a group.
•
Collect port usage data for all ports in a group.
You can see all port groups; however, under each group, you can only see devices that belong to
your area of responsibility (AOR). You can only see user-defined port groups that belong to your
AOR.
Firmware
The firmware version of the product.
Build Label
The firmware build number.
Location
The physical location of the product.
Contact
The name of the person or group you should contact about the product.
Description
The description of the product.
Connected AP Count
The number of connected AP.
User_defined_property (up to 3)
A user-defined product property value. You can create up to 3
user-defined properties (refer to
TABLE 28
Field/Component
Description