Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1213)

Brocade Network Advisor SAN + IP User Manual 1161
53-1002949-01
Adding thresholds
29
Adding thresholds
NOTE
This feature requires a Trial or Licensed version.
The Management application allows you to create Invalid CRCs, Invalid words, Link, Link Reset,
Protocol Error, Security, and Sync Loss thresholds.
Adding a C3 Discard Frames threshold
NOTE
This threshold is only available for Fabric OS devices running 6.3 or later.
Use to block a port when a C3 Discard Frames violation type meets the Fabric OS switch threshold.
For default threshold values for Fabric OS devices, refer to Chapter 7 of the Fabric Watch
Administrator's Guide.
To add an C3 Discard Frames threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
The Port Fencing dialog box displays ( Figure 491 ).
FIGURE 491 Port Fencing dialog box
2. Select C3 Discard Frames (Fabric OS only) from the Violation Type list.