Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1297)

Brocade Network Advisor SAN + IP User Manual 1247
53-1002949-01
Creating a payload configuration
33
Creating a payload configuration
The Configuration Wizard facilitates the creation and deployment of payload configurations.
1. Select Configure > Configuration Wizard.
2. Click Add.
The Select Payload pane displays, as shown in Figure 536 . This pane displays all of the
payloads you can deploy to wired devices.
Payloads are grouped under Product Payloads or Interface Payloads. Product payloads are
deployed to the devices, whereas interface payloads are deployed to ports.
TACACS+ Servers Indicates which TACACS/TACACS+ servers are to be used for authentication.
Telnet Sets Telnet password and idle timeout value, and enables Telnet authentication
on devices for use with AAA authentication.
Time Zone/SNTP Specifies the time zone and specifies whether the date and time are to be set
by an SNTP server clock.
User Accounts Configures accounts for users and administrators who are allowed to access
the product.
Interface Payloads:
LDP Settings Configures LDP settings on an interface.
PoE Control Powers up and powers down an interface that can be powered up over an
Ethernet connection.
Port Changes basic port parameters in VLAN Manager.
sFlow Configuration Enables and configures sFlow on a device, globally or per interface
SNMP Trap for Port Specifies whether a link-change trap is sent if the state of a port changes.
TABLE 129 Payloads available for deployment (Continued)
Payload name Description