Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1050)

996 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Tape LUN statistics
25
3. Select a tape target storage device, then click LUNs.
The Target Tape LUNs dialog box displays. (Refer to Figure 428 .) A list of the configured tape
LUNs is displayed.
FIGURE 428 Target Tape LUNs dialog box
4. Select the LUN or LUNs for which to display or clear statistics, then click Statistics.
The Tape LUN Statistics dialog box displays. (Refer to Figure 429 .) The statistic results based
on the LUN or LUNs you selected is displayed. Tape LUN statistics are cumulative.
FIGURE 429 Tape LUN Statistics dialog box
The dialog box contains the following information:
• LUN #: The number of the logical unit for which statics are displayed.
• Tape Volume/Pool: The tape volume label of the currently-mounted tape, if a tape session
is currently in progress.
• Tape Session #: The number of the ongoing tape session.
• Uncompressed blocks: The number of uncompressed blocks written to tape.
• Compressed blocks: The number of compressed blocks written to tape.
• Uncompressed Bytes: The number of uncompressed bytes written to tape.
• Compressed Bytes: The number of compressed bytes written to tape.