Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 638)

576 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Port commissioning overview
14
2. Choose one of the following options:
• Apply Default Settings (default) — Select to have the Management application perform one
of the following actions:
The Management application contact all registered CIMOM servers within the fabric
affected by the action and obtains the status from each CIMOM server. If all CIMOM
servers are okay, the Management application sends a CAL Request to decommission the
port. If even one CIMOM server is not okay, decommissioning fails.
• Force — Select to force the port decommission.
The Management application still contacts all registered CIMOM servers within the fabric
affected by the action, but forces the port decommission regardless of the CIMOM server
response.
NOTE
If the CIMOM server is not reachable or the credentials fail, port decommission does not
occur.
3. Click OK on the Port Commission Confirmation dialog box.
While decommissioning is in progress, a down arrow icon displays next to the port icon in the
Product List. You can view the port commissioning results in the deployment reports (refer to
“Port commissioning deployment report” on page 577).
When the decommission is complete, an application event displays in the Master Log detailing
success or failure.
Recommissioning all ports on a switch
Select the switch or logical switch for which you want to recommission all ports, then select
Configure > Port Commissioning > Recommission > All F-Ports on the Switch.
NOTE
You can only recommission ports from the logical switch, not the physical chassis.
While recommissioning is in progress, an up arrow icon displays next to the port icon in the Product
List. You can view the port commissioning results in the deployment reports (refer to
“Port
commissioning deployment report” on page 577).
When the recommission is complete, an application event displays in the Master Log detailing
success or failure.