Searching for a device by wwn – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 256
190
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Name settings
6
4. Enter the name you want to search for in the Search field.
You can search on partial names.
NOTE
To search for a device, the device must be discovered and display in the topology.
5. Click Search.
All devices with the specified name (or partial name) are highlighted in the Display table. You
may need to scroll to see all highlighted names.
If the search finds no devices, a ‘no item found’ message displays.
6. Click OK to close the Configure Names dialog box.
Searching for a device by WWN
You can search for objects (switch, fabric, product, ports, or N Ports) by WWN (world wide name). To
search for a WWN in the Connectivity Map, refer to
To search by WWN, complete the following steps.
1. Select Configure > Names.
The Configure Names dialog box displays.
2. Select All Names from the Display list.
3. Select WWN from the Scope list.
4. Enter the WWN you want to search for in the Search field.
You can search on partial WWNs.
NOTE
To search for a device, the device must be discovered and display in the topology.
5. Click Search.
All devices with the specified WWN (or partial WWN) are highlighted in the Display table. You
may need to scroll to see all highlighted WWNs.
If the search finds no devices, a ‘no item found’ message displays.
6. Click OK to close the Configure Names dialog box.