Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 2018)

1978 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
IP device properties
E
Controller cluster name Only applicable to the selected controller. Cluster name.
Controller cluster members Only applicable to the selected controller. IP addresses of the controller
cluster peers.
Cluster (MCT switches only) The cluster details of the Multi-Chassis Trunk (MCT) switch. MCT cluster
details include:
•
Cluster ID — The MCT cluster ID.
•
Cluster Name — The MCT cluster name.
•
Cluster RBridge ID — The RBridge ID of the MCT cluster.
•
Cluster State — Whether the MCT cluster is deployed or undeployed.
•
Isolation Mode — Whether isolation mode is loose or strict.
•
Active Member VLAN Range — The active member VLAN for data.
•
Configure Member VLAN Range — The configured member VLAN for
data.
•
Keep Alive VLAN — An alternate VLAN for Cluster Communication
Protocol (CCP) when the Inter-Chassis Link (ICL) is down.
•
Session VLAN — The VLAN used by the cluster for control
operations.
•
ICL Name — The ICL name.
Cluster Peer (MCT switches only) The cluster peer details of the MCT switch. MCT cluster peer details
include:
•
Peer Product — The name and IP address of the MCT peer product.
•
Peer IP Address — The VE interface IP address of the MCT peer.
•
Peer RBridge ID — The RBridge ID of the MCT peer.
•
ICL Name — The name of the ICL used to reach the MCT peer.
•
Keep Alive Interval — The Interval time for CCP over the keep-alive
VLAN.
•
Hold Time — The hold-time before making the CCP down state when
ICL goes down.
•
Fast Failover — Whether fast failover is enabled or disabled.
•
Active VLAN Range — The active member VLAN for data.
•
Peer State — Whether the peer state is CCP up or CCP down.
•
Peer State Up Time — How long the peer has been up.
•
Peer State Down Reason — The reason the peer is down.
Add button Click to add a user-defined property. For more information, refer to
“Adding a property field” on page 1991.
Edit button Click to edit a user-defined property. For more information, refer to
“Editing a property field” on page 1991.
Delete button Click to delete a user-defined property. For more information, refer to
“Deleting a property field” on page 1992.
Nodes tab Select to display information about nodes in the fabric. For detailed
information about this tab, refer to
“Viewing VCS fabric properties” on
page 1980.
Port Profiles tab Select to display information about port profiles for the fabric members.
For detailed information about this tab, refer to
“Viewing VCS fabric
properties” on page 1980.
Ports tab Select to display information about ports on the device.
Field/Component Description