Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1042)

988 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Adding target tape LUNs for encryption
25
FIGURE 421 Encryption Targets dialog box
3. Select a target tape storage device from the Encryption Targets table, then click LUNs.
The Encryption Target Tape LUNs dialog box displays. (Refer to Figure 422 .)
FIGURE 422 Encryption Target Tape LUNs dialog box
4. Click Add.
The Add Encryption Target Tape LUNs dialog box displays. (Refer to Figure 423 .) A table of all
LUNs in the storage device that are visible to hosts is displayed. LUNs are identified by the Host
world wide name, LUN number, Volume Label Prefix number, and Enable Write Early ACK and
Enable Read Ahead status. The LUN numbers may be different for different hosts.