Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1758)

1716 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
SNMP traps
48
To forward SNMP traps, complete the following steps.
1. Select Monitor > SNMP Setup > Trap Forwarding.
The SNMP Trap Forwarding dialog box, shown in Figure 735 , displays.
FIGURE 735 SNMP Trap Forwarding dialog box
Adding a trap destination
The Add Trap Destination dialog box allows you to configure destinations for forwarding SNMP
traps.
To add a trap destination, complete the following steps.
1. Select Monitor > SNMP Setup > Trap Forwarding.
The SNMP Trap Forwarding dialog box, shown in Figure 735 , displays.
2. Select the Enable trap forwarding check box.
3. Click Add in the Destinations area of the SNMP Trap Forwarding dialog box.
The Add Trap Destination dialog box, shown in Figure 736 , displays.