Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 858)

802 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Layer 3 access control list policy
22
To delete a network group, complete the following steps.
1. Click the Network Groups tab.
2. Select one or more network groups that you want to delete in the List of Network Groups table
and click Delete.
3. Click Yes on the confirmation message.
4. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Service configuration
The Management application allows you to filter traffic from a specific service source or destination
port. A service is either TCP or UDP port. Use the following procedures to configure a service:
• “Viewing existing services” on page 802
• “Creating a service” on page 803
• “Editing a service” on page 804
• “Copying a service” on page 805
• “Deleting a service” on page 805
Viewing existing services
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an extended L3 ACL configuration” on page 779
• “Copying an extended L3 ACL configuration” on page 780
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an IPv6 L3 ACL configuration” on page 783
• “Copying an IPv6 L3 ACL configuration” on page 784
To view all existing services, complete the following steps.
1. Click the Services tab.