Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 1720
Brocade Network Advisor SAN + IP User Manual
1677
53-1002949-01
Adding a policy monitor
47
d. Select the switches or routers to which you want to apply this policy in the Available
Switches/Routers list and click the right arrow button.
NOTE
You can use the All Fabrics and All SAN Switches targets (under the Product Groups >
System Product Groups node) in the Available Switches/Routers list) for future
provisioning. Select All Fabrics and click the right arrow button to apply this policy to all
discovered fabrics. Select All SAN Switches and click the right arrow button to apply this
policy to all discovered switches.
The selected switches display in the Selected Switches/Routers list.
8. To set policy monitors for hosts, select the Host Checks tab (
) and complete the
following steps.
FIGURE 725
Add Policy Monitor dialog box, Hosts Checks tab
a. Select the Check for redundant connections to attached fabrics check box to determine if
there are at least the minimum number of configured physical connections between the
host and the attached fabric.
The default is 2. For more information about this check and a fix for rule violations, refer to
b. Enter the minimum number of connections between the host and the attached fabric in
the Minimum Connections field.
The default is 2.