Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 849)

Brocade Network Advisor SAN + IP User Manual 793
53-1002949-01
Layer 3 access control list policy
22
14. Click OK on the Advanced Settings dialog box.
To finish configuring the ACL, return to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an extended L3 ACL configuration” on page 779
• “Copying an extended L3 ACL configuration” on page 780
• “Creating an IPv6 L3 ACL configuration” on page 781
• “Editing an IPv6 L3 ACL configuration” on page 783
• “Copying an IPv6 L3 ACL configuration” on page 784
Network configuration
The Management application allows you to filter traffic from a specific Network. A Network is made
up of one or more devices in a subnet. Use the following procedures to configure a network:
• “Viewing existing networks” on page 793
• “Creating a network” on page 794
• “Editing a network” on page 795
• “Copying a network” on page 796
• “Deleting a network” on page 796
Viewing existing networks
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 773
• “Editing a standard L3 ACL configuration” on page 775
• “Copying a standard L3 ACL configuration” on page 776
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an extended L3 ACL configuration” on page 779
• “Copying an extended L3 ACL configuration” on page 780
To view all existing networks, complete the following steps.