Configuring a one-time discovery schedule – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 177
110
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
IP discovery profiles
4
3. Select the profile you want to edit in the Discovery Profiles table and click the Scheduling tab.
FIGURE 32
Scheduling tab
4. Choose one of the following options to configure the frequency at which discovery runs for the
profile:
•
To configure discovery to run only once, refer to
“Configuring a one-time discovery
•
To configure hourly discovery, refer to
“Configuring an hourly discovery schedule”
•
To configure daily discovery, refer to
“Configuring a daily discovery schedule”
•
To configure weekly discovery, refer to
“Configuring a weekly discovery schedule”
•
To configure monthly discovery, refer to
“Configuring a monthly discovery schedule”
•
To configure yearly discovery, refer to
“Configuring a yearly discovery schedule”
5. Rearrange schedules in the Scheduled Discovery Cycles list by selecting an item in the list and
clicking the Up or Down buttons to move it.
6. Click Apply to save your changes.
7. Click Close to close the Discover Setup - IP dialog box.
8. Click Yes on the confirmation message.
Configuring a one-time discovery schedule
To configure a one-time discovery schedule, complete the following steps.
1. Select One Time from the Frequency list.
FIGURE 33
Scheduling tab - One Time