Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1735)

1692 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Configuration rules
47
Selecting a product
You can only select one product at a time.
1. From the Add Condition dialog box, click the Product ellipsis button to select a product.
The Select Product dialog box displays.
2. Select a product from the Available Products list, and click the right arrow button to move the
product to the Selected Product table.
The Available Products list contains the same fields as the IP Product list (refer to “IP Product
List” on page 373).
3. To remove a product from the Selected Product list, select the product and click the left arrow
button to move the product to the Available Products list.
The Selected Product list contains the same fields as the IP Product list (refer to “IP Product
List” on page 373).
4. Click OK on the Select Product dialog box.
Duplicating a configuration condition
Enables you to create a new condition based on a predefined or user-defined condition.
1. Select Monitor > Policy Monitor.
The Policy Monitor dialog box displays.
2. Click Edit.
The Edit Monitor dialog box displays.
3. Click the Switch/Router Checks tab.
4. Select the configuration rule you want to edit in the Available Checks list and click Edit.
The Edit Configuration Rule dialog box displays.
5. Select the predefined or user-defined condition you want to edit and click Add > Condition.
The Add Condition dialog box displays.
6. Change the user-defined name for the rule in the Name field, if necessary.
The name must be unique. The name cannot be over 128 characters. The only special
character allowed is an underscore (_).
7. Change the description of the rule in the Description field, if necessary.
The description cannot be over 1024 ASCII characters.
8. To edit a configuration condition, repeat step 8 through step 13 of “Adding a configuration
condition” on page 1690.
9. Click OK on the Add Condition dialog box.
10. Click OK on the Edit Configuration Rule dialog box.
11. Click OK on the Edit Monitor dialog box.
The updated policy monitor displays in the Monitors table of the Policy Monitor dialog box.
12. Click Close on the Policy Monitor dialog box.