Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 247)

Brocade Network Advisor SAN + IP User Manual 181
53-1002949-01
Flyover settings
6
c. Click the right arrow to move the selected properties to the Selected Properties table.
d. Use the Move Up and Move Down buttons to reorder the properties in the Selected
Properties table, if necessary.
The properties displayed in the Selected Properties table appear in the flyover display.
6. Remove product properties you do not want to display on flyover by selecting the property in the
Selected Properties table and clicking the left arrow.
7. Add connection properties you want to display on flyover by selecting the Connection tab
( Figure 66 ) and completing the following steps.
FIGURE 66 Options dialog box (Flyovers pane, Connection tab)
a. Select the protocol type (FC or IP) from the Type list, if necessary.
The default protocol is FC. Depending on which protocol you select, some properties may
not be available for all protocols.
b. Select each property you want to display in the connection flyover from the Available
Properties table.
Depending on which protocol you select, some of the following properties may not be
available for all protocols: