Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 838
782
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Layer 3 access control list policy
22
6. Choose one of the following options from the Source list:
•
To enter an IP address, select IP Address and complete the following steps:
a. Enter the source IP address on which the ACL filters traffic in the IP Address list and
text field.
You can enter the IPv6 address in compressed (for example, you can compress
2001:db8:0:0:0:0:2:1 can be shortened to 2001:db8::2:1) or raw format.
b. Enter the prefix length (1 through 128) in the Prefix Length field.
•
To enter an IPv6 address, select IP Address and complete enter the source IPv6 address
on which the ACL filters traffic in the IP list and text field.
•
To select a network, select IP Address and choose a network from the list.
•
To enter a host name, select Host and enter the source host name on which the ACL filters
traffic in the Host list and text field.
7. Choose one of the following options from the Destination list:
•
To enter an IP address, select IP Address and complete the following steps:
a. Enter the destination IP address on which the ACL filters traffic in the IP Address list
and text field.
You can enter the IPv6 address in compressed (for example, you can compress
2001:db8:0:0:0:0:2:1 can be shortened to 2001:db8::2:1) or raw format.
b. Enter the prefix length (1 through 128) in the Prefix Length field.
•
To select a network, select IP Address and choose a network from the list.
•
To enter a host name, select Host and enter the destination host name on which the ACL
filters traffic in the Host list and text field.
8. Enter a VLAN identifier (valid values are from 1 to 4095) from the VLAN list.
9. Select the Log Enable check box to enable logging.
10. Click Advanced Settings to configure additional settings for the ACL configuration.
NOTE
You must configure advanced settings to create an extended Layer 3 ACL.
The L3 ACL Advanced Settings dialog box displays.
FIGURE 277
Add - L3 Advanced Settings dialog box (IPv6)