Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 191
124
Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Individual IP device discovery
4
d. Enter the SNMPv3 authentication password in the Authentication Password field.
The password can be from 8 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password display as asterisks.
e. Select one of the following privacy protocol types from the Privacy Protocol list:
•
None
•
CBC-DES
•
CFB_AES-128
If you select a privacy protocol, the selected protocol encrypts the SNMP request and
response packets.
f.
Enter the privacy password in the Privacy Password field.
The password can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password display as asterisks.
7. Configure the SNMPv1 and SNMPv2c read-write credentials by completing the following steps.
a. Click the SNMPv1/v2c Read/Write tab.
FIGURE 42
SNMPv1/v2c credentials
b. Enter the community string in the Community field.
The community string can be from 1 through 16 characters long, case sensitive, and
allows all printable ASCII characters. The string displays as asterisks.
NOTE
If you do not enter a community string in the field, discovery uses the "public" and "private"
community strings to probe the devices.
8. Configure the SNMPv1 and SNMPv2c read only credentials by completing the following steps.
a. Click the SNMPv1/v2c Read Only tab.
b. Enter the community string in the Community field.
The community string can be from 1 through 16 characters long, case sensitive, and
allows all printable ASCII characters. The string displays as asterisks.
NOTE
If you do not enter a community string in the field, discovery uses the "public" and "private"
community strings to probe the devices.