Enhanced group management, Table 68, Table 69 – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 605
Brocade Network Advisor SAN + IP User Manual
543
53-1002949-01
Enhanced group management
14
Enhanced group management
Use Enhanced Group Management (EGM), a separate licensed feature, to control access to
specific features on Fabric OS devices. The features affected include the following:
•
Firmware Download - enables you to perform group firmware download.
For specific instructions for firmware download, refer to
•
Security - enables you to perform Group Security Policy Replication.
For specific instructions for security, refer to
“Configuration repository management”
•
Configuration Management - enables you to perform Group Configuration Upload and
Replication.
For specific instructions for configuration management, refer to
Description
A description of the customer site.
State
The port state, for example, online or offline.
Status
The operational status of the port; for example, unknown or marginal.
Right and left arrow buttons
Click to move the switches back and forth between the Available
Switches table and the Selected Switches table.
Selected Switches table
Lists the switches selected as the destination switches.
Switch Name
The name of the switch selected to be the destination switch.
IP
The IP address of the switch selected to be the destination switch.
WWN
The world wide name of the switch selected to be the destination switch.
Current Firmware Status
The status of the current firmware.
TABLE 68
Step 5. Validation
Field/Component
Description
Validation Settings table
The replication settings that have been configured in previous steps; for
example, the configuration type, source configuration, and destination
settings. Click Finish to approve the settings.
Disable Destination Switch check box
Select to disable the destination switch during replication.
TABLE 69
Step 6. Summary
Field/Component
Description
Summary table
The replication settings that have been successfully applied to the
selected destination switches; for example, the configuration type,
source configuration, and destination settings. Click Close to close the
dialog box.
TABLE 67
Step 4. Select Destination Switches (Continued)
Field/Component
Description