Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 685
Brocade Network Advisor SAN + IP User Manual
627
53-1002949-01
Port profiles
18
Port profile configuration using the management application
You can manage MAC addresses and port profiles from the Port Profiles tab of the Fabric_Name
Properties dialog box, as shown in
Figure 220
.
FIGURE 220
Fabric_Name Properties dialog box — Port Profile tab
Deleting a port profile
An in-use error is generated if the port profile is in an activated state. AMPP forces you
to de-activate the profile before deleting.
If the port profile is in an inactive state, then deletion of the port profile removes all
the MAC address associations as well.
Modifying port profile
content when in an
associated state
An in-use error is generated if the port profile is already activated.
Moving the VM MAC
address and notifying
the fabric
All policies associated with the port profile ID are mapped on the MAC address and
applied to the new port in the fabric.
Unused port profile
You must manually remove the MAC address mapping to remove any MAC address
association.
TABLE 80
AMPP behavior and failure descriptions (Continued)
AMPP event
Applicable behavior and failures