Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1076)

1022 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Viewing and editing switch encryption properties
25
FIGURE 445 Encryption Targets Disk LUNs dialog box - Time left for auto rekey
Viewing and editing switch encryption properties
To view switch encryption properties, complete the following steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 303 on page 852.)
2. Select a switch or encryption engine from the Encryption Center Devices table, then select
Switch/Engine > Properties from the menu task bar, or right-click a switch or encryption engine
and select Properties.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Properties icon.
The Encryption Switch Properties dialog box displays. (Refer to Figure 446 .)