Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1766)

1724 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
SNMP traps
48
Trap customization
The Trap Configuration tab of the Event Reception dialog box enables you to configure the following
settings:
• Register and unregister various Management Information Bases (MIBs)
• Customize trap description messages based on varbinds and severity and specify alias names
Registering traps
Traps must be registered in the Event Reception dialog box to make them available.
To register traps, complete the following steps.
1. Select Monitor > SNMP Setup > Event Reception.
2. Click the Trap Configuration tab.
The Trap Configuration tab of the Event Reception dialog box, shown in Figure 741 , displays.
The Registered and Not Registered buttons at the top of the Traps tree serves as a filter for the
traps. If there are unregistered traps, they are listed when you select the Not Registered
button.
Traps appear under each MIB folder. The MIB folders correspond to the MIBs identified in the
mibs_to_compile.txt file.
FIGURE 741 Trap Configuration tab of the Event Reception dialog box
3. Expand a folder for a MIB to display the traps in the MIB. If the list is too long, use the Search
tool to find a MIB or trap.