Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1744)

Brocade Network Advisor SAN + IP User Manual 1701
53-1002949-01
Running a policy monitor
47
Running a policy monitor
Before you run a policy monitor, make sure your policy monitors are valid. Valid policy monitors
must have at least one policy selected with one or more targets. Management checks do not
require a target.
To run an existing policy monitor, complete the following steps.
1. Select Monitor > Policy Monitor.
The Policy Monitor dialog box displays.
2. Select the policy you want to run in the Monitors list.
3. Click Run.
When the policy monitor check is complete, the Policy_Name - Policy Monitor Report displays
(
Figure 730 ) in a web browser.
FIGURE 730 Policy_Name - Policy Monitor Report
4. Review the report details (refer to “Viewing a policy monitor report” on page 1702).
To export a report, refer to “Exporting a policy monitor report” on page 1704.
To e-mail a report, refer to “Exporting IP reports to e-mail recipients” on page 1858.
5. Click the close button (X) on the Policy_Name - Policy Monitor Report browser window.
6. Click Close on the Policy Monitor dialog box.