Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1095)

Brocade Network Advisor SAN + IP User Manual 1041
53-1002949-01
Viewing and editing encryption group properties
25
Adding tape pools
A tape pool can be identified by either a name or a number, but not both. Tape pool names and
numbers must be unique within the encryption group. When a new encryption group is created, any
existing tape pools in the switch are removed and must be added.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 303 on page 852.)
2. Select a group from the Encryption Center Devices table, then select Group > Tape Pools from
the menu task bar.
NOTE
If groups are not visible in the Encryption Center Devices table, select View > Groups from the
menu task bar.
3. Click Add.
The Add Tape Pool dialog box displays. (Refer to Figure 455 .) The Name tape pool label type is
the default; however, you can change the tape pool label type to Number (Refer to Figure 456 .)
FIGURE 455 Add Tape Pool by name dialog box
FIGURE 456 Add Tape Pool by number dialog box
4. Based on your selection, do one of the following:
• If you selected Name as the Tape Pool Label Type, enter a name for the tape pool. This
name must match the tape pool label or tape ID that is configured on the tape
backup/restore application.
• If you selected Number as the Tape Pool Label Type, enter a (hex) number for the tape
pool. This number must match the tape pool label or tape number that is configured on
the tape backup/restore application.