Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1036)

982 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Adding target disk LUNs for encryption
25
FIGURE 417 Select Initiator Port dialog box
The dialog box is used to select an initiator port when configuring multiple I/O paths to a disk
LUN. The dialog box contains the following information:
• Storage Array: Displays the storage array that was selected from the LUN view prior to
launching the wizard.
• Host: The host selected from the LUN view prior to launching the wizard.
• Initiator Port table: Lists initiator ports using the following identifiers:
- Initiator Port
- Initiator Port Name
- Initiator Node Name
- Fabric
5. Select the initiator port from the Initiator Port table, then click Next.
LUN discovery is launched and a progress bar displays. There are four possible outcomes:
• A message displays indicating no LUNs were discovered. Click OK to dismiss the message
and exit the wizard.
• A message displays indicating LUNs have been discovered, but are already configured.
Click OK to dismiss the message and exit the wizard.
• A message displays indicating that the target is not in the right state for discovering LUNs.
Click OK to dismiss the message and exit the wizard.
• The Select LUN dialog box displays, which lists discovered LUNs that are available. (Refer
to
Figure 418 .)