Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 152)

Brocade Network Advisor SAN + IP User Manual 85
53-1002949-01
IP SNMP credentials
4
4. Enter a unique label to identify the credentials in the Display Label field of the Add/Edit
SNMPv3 Read-Write Credentials area.
This label can be from 1 through 16 characters long, case sensitive, and allows all printable
ASCII characters.
5. Enter the SNMPv3 user name in the User ID field.
The user name can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters.
6. Select one of the following protocols from the Authentication Protocol list:
• None
• HMAC_MD5
• HMAC_SHA
7. Enter the SNMPv3 authentication password in the Authentication Password field.
The password can be from 8 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password displays as asterisks.
8. Select one of the following protocols from the Privacy Protocol list:
• None
• CBC-DES
• CFB_AES-128
If you select a privacy protocol, the selected protocol encrypts the SNMP request and response
packets.
9. Enter the privacy password in the Privacy Password field.
The password can be from 1 through 16 characters long, case sensitive, and allows all
printable ASCII characters. The password displays as asterisks.
10. Click the right arrow button to add the SNMPv3 read-write credentials to the Selected SNMPv3
Read-Write Credentials list.
NOTE
If the devices use multiple credentials, use the Up or Down buttons to place the most
commonly used credentials at the top of the Selected SNMPv3 Read-Write Credentials list to
make discovery run more efficiently.
11. Click Apply to save your work.
12. Click Close to close the Discover Setup - IP dialog box.
13. Click Yes on the confirmation message.