Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 285)

Brocade Network Advisor SAN + IP User Manual 219
53-1002949-01
Software Configuration
6
For all 64-bit servers, the default minimum Server Heap Size for all network sizes is 2048 MB.
NOTE
There is no restriction on the maximum value for Server Heap Size in a 64-Bit Server. The
correct server heap size value must be given according to the RAM present in the server.
7. Click Apply or OK to save your work.
NOTE
Changes to this option take effect after an application restart.
NOTE
You can only restart the server using the Server Management Console (Start > Programs >
Management_Application_Name 12.X.X > Server Management Console).
8. Click OK on the “changes take effect after application restart” message.
Configuring asset polling
NOTE
Asset polling is only applicable for SAN products and Fabric OS DCB products discovered from the IP
tab.
Asset polling allows you set the length of time between state change polling. To maximize the
efficiency of the polling feature (balance the amount of possible information with any possible
performance impact), base your settings on the size of the SAN.
To configure asset polling, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Memory Allocation in the Category list to set the memory allocation for the server and
client.
The Memory Allocation pane displays ( Figure 79 ).
3. Enter how often you want to check for state changes in the Check for state change every field.
Valid values are from 1 through 600 seconds. You cannot enter a value lower than the default
minimum value.
Default minimum values are as follows:
• Small (Professional): 60 seconds
• Medium: 120 seconds
• Large: 180 seconds
Medium SAN Enterprise 1024 MB 1024 MB 1400 MB
Large SAN Enterprise 1200 MB 1400 MB 1500 MB
TABLE 33 Server Heap Size for 32-bit Linux Server
Small LAN Medium LAN Large LAN