Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1770)

1728 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Syslogs
48
FIGURE 742 Syslog Recipients dialog box
2. Select Add from the Action list.
3. Enter the IP address of the syslog port (the recipient server) in the Recipient IP Address field.
This is a mandatory field. IPv4 addresses are accepted, but a DNS name is not accepted.
4. Enter the syslog port of the recipient in the Recipient Port field. Valid numeric values range
from 1 through 65535. The default value is 514.
NOTE
For IronWare products, a non-default port can be registered. For Network OS and Fabric OS
products, non-default ports cannot be registered.
5. Select the fabric or switches from the Available list and click the right arrow button to move it to
the Selected list. You can select multiple products.
NOTE
For IP products, only switches are available to select.
6. Click OK.
The Management application registers the recipient IP address as a syslog recipient.
Removing a syslog recipient
To remove a syslog recipient, complete the following steps.
1. Select Monitor > Syslog Configuration > Syslog Forwarding.
The Syslog Recipients dialog box displays.
2. Select Remove from the Action list.
3. Enter the IP address of the syslog port (the recipient server) in the Recipient IP Address field.
4. Select the fabric or switches from the Available list.
5. Click OK.