Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 996)

942 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Creating a new encryption group
25
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See
“Understanding configuration status
results” on page 959 for more information.
11. Review important messages, then click Next.
The Next Steps dialog box displays. (Refer to Figure 374 .) Instructions for installing public key
certificates for the encryption switch are displayed.
FIGURE 374 Next Steps dialog box
12. Review post-configuration instructions, which you can copy to a clipboard or print for later.
13. Click Finish to exit the Configure Switch Encryption wizard.
14. Refer to “Understanding configuration status results” on page 959.