Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 295)

Brocade Network Advisor SAN + IP User Manual 229
53-1002949-01
Software Configuration
6
4. Enable HTTP redirection to HTTPS by selecting the Redirect HTTP Requests to HTTPS check
box.
When you enable HTTP redirection, the server uses port 80 to redirect HTTP requests to
HTTPS. Make sure that port 80 is available before you enable HTTP redirection.
5. Enter a port number in the Starting Port # field.
The default is 24600.
For Professional, the server requires 15 consecutive free ports beginning with the starting port
number.
For Trial and Licensed versions, the server requires 18 consecutive free ports beginning with
the starting port number.
6. Click Apply or OK to save your work.
NOTE
Changes to this option take effect after application restart.
7. Click OK on the “changes take effect after application restart” message.
Support mode settings
You can configure support settings to allow enhanced diagnostics.
Configuring support mode settings
To configure support mode settings, complete the following steps.
1. Select Server > Options.
The Options dialog box displays ( Figure 86 ).
2. Select Support Mode in the Category list.
NOTE
Only use this option when directed to by customer support.
The Support Mode pane displays ( Figure 85 ).
FIGURE 86 Options dialog box (Support Mode pane)
3. Select the Log client support data - Log Level list, and select the type of log data you want to
configure.
Log level options include: All, Fatal, Error, Warn, Info, Debug, Trace, and Off. Default is Info.