Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 735)

678 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
DCB configuration management
20
DCB configuration management
Depending on the platform, the DCB switch has one of the configurations shown in Table 89 .
You must configure DCB interfaces and ports differently than you configure Fibre Channel ports to
effectively use the converged network features.
For example, priority-based flow control (PFC) and Enhanced Transmission Selection (ETS) are the
two QoS policy enhancements you must configure to create a lossless Ethernet. You then use DCBX
protocol on DCB-enabled devices to exchange configuration information.
The DCB ports of FOS DCB devices are categorized into two types:
• External ports - The eight external ports are the same as the original 10 Gbps Ethernet DCB
ports. The default name in the device tree is ExT /.
• Internal ports - The default name for the 12 or 14 internal ports is InT /.
802.1x, LAG configuration, and Spanning Tree Protocol (STP) are not supported on internal
ports.
TABLE 89 DCB configurations
Device type Configuration possibilities
IBM blade server
•
14 internal 10-Gbps ports for IBM BladeCenter H
(BCH) chassis type
•
12 internal 10-Gbps ports IBM BladeCenter HT
(BCHT) chassis type
•
8 external 10-Gbps DCB ports
•
8 8-Gbps FC ports
Dell embedded switch module
•
16 10-Gbps internal ports
•
8 10-Gbps external ports
•
4 8-Gbps FC ports
Fabric OS DCB switch
•
8 16-Gbps FC ports
•
24 10-Gbps Ethernet ports
Fabric OS FCOE10-24 blade 24 10-Gbps Ethernet ports
Network OS VDX switches
•
Network OS VDX 2730 10 Gbps connection blade
•
Network OS VDX 6710 switch
•
Network OS VDX 6720-24 switch
•
Network OS VDX 6720-60 switch
•
Network OS VDX 6730-32 switch
•
Network OS VDX 6730-76 switch
•
Network OS VDX 6740 switch
•
Network OS VDX 6740T switch
•
Network OS VDX 8770-4 switch
•
Network OS VDX 8770-8 switch