Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 149)

82 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Configuring IP simple discovery
4
2. Click the Global Settings tab.
a. To set SNMP credentials, refer to “IP SNMP credentials” on page 83.
b. To configure default user names and passwords, refer to “Default IP user credentials” on
page 89.
c. To configure global setting preferences, refer to “Defining global setting preferences” on
page 97.
3. Click the Profiles tab.
a. To create a discovery profile, refer to “IP discovery profiles” on page 101.
b. To include and exclude product types, refer to “IP Object identifier filters” on page 95.
c. To include and exclude devices and enable ping sweep, refer to “Configuring address
ranges” on page 104.
d. To configure profile preferences, refer to “Configuring advanced discovery profile
preferences” on page 116.
4. Click Start to start discovery. To run profile discovery, refer to “Starting discovery manually” on
page 118.
5. Click Close to close the Discover Setup - IP dialog box.
6. Click Yes on the confirmation message.
Configuring IP simple discovery
NOTE
The Discovered Products table lists all products discovered through individual product discovery,
profile-based discovery, as well as Fabric discovery (from the SAN tab).
NOTE
DCB devices discovered through Fabric discovery (from the SAN tab) are automatically added to IP
discovery during rediscovery.
NOTE
You must have the All IP Products AOR (area of responsibility) in your user account to discover new
products. For more information about user accounts, refer to
“User accounts” on page 241.
To configure simple discovery, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. To add individual devices, refer to “Adding an IP device to discovery” on page 121.
3. Click Close to close the Discover Setup - IP dialog box.
4. Click Yes on the confirmation message.