Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 986)

932 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Creating a new encryption group
25
FIGURE 361 Next Steps dialog box
13. Review the post-configuration instructions, which you can copy to a clipboard or print for later,
then click Finish to exit the wizard.
Configuring key vault settings for NetApp Link Key Manager
(LKM/SSKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
“Creating a new encryption group”
on page 922.
Figure 362 shows the key vault selection dialog box for LKM/SSKM.