Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 172)

Brocade Network Advisor SAN + IP User Manual 105
53-1002949-01
IP discovery profiles
4
Adding CIDR subnet addresses
To add CIDR subnet addresses (IPv4 and IPv6), complete the following steps.
1. Select CIDR Subnet from the Entry Type list.
FIGURE 26 Include CIDR Subnet
2. Enter the IP address in the IP Address field.
3. Enter the number of subnet mask bits in the Subnet Mask Bits field.
For IPv4, the number of subnet mask bits is from 0 through 32.
For IPv6, the number of subnet mask bits is from 0 through128.
4. To exclude an address range using the CIDR Subnet format, refer to “Excluding CIDR subnet
addresses” on page 106.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 104.
Adding subnet addresses
To add subnet addresses (IPv4 only), complete the following steps.
1. Select Subnet from the Entry Type list.
FIGURE 27 Include Subnet
2. Enter the IP address in the IP Address field.
3. Enter the subnet mask in the Subnet Mask field.
4. To exclude an address range using the Subnet format, refer to “Excluding subnet addresses”
on page 107.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 104.