Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1722)

Brocade Network Advisor SAN + IP User Manual 1679
53-1002949-01
Policy monitor scheduling
47
Policy monitor scheduling
You can schedule a policy monitor to run automatically. For step-by-step instructions, refer to the
following procedures:
• “Configuring a one-time policy monitor schedule” on page 1679
• “Configuring an hourly policy monitor schedule” on page 1679
• “Configuring a daily policy monitor schedule” on page 1679
• “Configuring a weekly policy monitor schedule” on page 1680
• “Configuring a monthly policy monitor schedule” on page 1680
Configuring a one-time policy monitor schedule
To configure a one-time schedule, complete the following steps.
1. Select One Time from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Click the Date list to select a date from the calendar.
4. Click OK on the Schedule Properties dialog box.
To finish configuring the policy monitor, return to step 6 of “Adding a policy monitor” on
page 1673.
Configuring an hourly policy monitor schedule
To configure an hourly schedule, complete the following steps.
1. Select Hourly from the Frequency list.
2. Select the minute past the hour you want deployment to run from the Minutes past the hour
list.
Where the minute value is from 00 through 59.
3. Click OK on the Schedule Properties dialog box.
To finish configuring the policy monitor, return to step 6 of “Adding a policy monitor” on
page 1673.
Configuring a daily policy monitor schedule
To configure a daily deployment schedule, complete the following steps.
1. Select Daily from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.