Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1182)

Brocade Network Advisor SAN + IP User Manual 1129
53-1002949-01
Configuring FCIP tunnel advanced settings
27
4. Click OK.
Enabling Tperf test mode
To enable Tperf test mode, do the following:
1. Select Advanced Settings on the Add FCIP Tunnel or Edit FCIP Tunnel dialog box to display the
Advanced Settings dialog box.
2. From the Transmission tab, select the TPerf Test Mode check box.
3. Select the Tape Acceleration check box.
4. Click OK.
Tperf test mode should not be enabled during normal operations. It is only used for testing and
troubleshooting tunnels. Refer to the Fabric OS FCIP Administrator’s Guide for information about
Tperf.
Configuring QoS percentages
For 8 Gbps platforms, you can adjust QoS (Quality of Service) priority percentages from the preset
default values of 50% (High), 30% (Medium), and 20% (low). Values for the three priority levels
must equal 100%. A minimum of 10% is required for each level. You can adjust percentages in
increments of 1%. To configure QoS percentages, do the following:
1. Select Advanced Settings on the Add FCIP Tunnel or Edit FCIP Tunnel dialog box to display the
Advanced Settings dialog box.
2. From the Transmission tab, click the up and down arrows by the QoS (High), QoS (Medium),
and QoS (Low) percentage values to increase and decrease values.
Configuring IPSec and IKE policies
IPSec and IKE policies are configured from the Security tab. The screens and procedures are
platform-dependent.
Figure 474 on page 1130 shows the screen for the 8 Gbps Extension Switch
and 8 Gbps Extension Blade.
1. Select Advanced Settings on the Add FCIP Tunnel or Edit FCIP Tunnel dialog box to display the
Advanced Settings dialog box.
2. Select the Security tab.