Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1802)

1760 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Event custom reports
48
Defining report settings
You can configure report settings so that you see only a restricted set of information in a report.
NOTE
You can change the number of displayed event custom report records by following the procedure in
“Configuring custom report preferences” on page 211. By default, 1000 records display, even if the
event count is greater than 1000.
NOTE
You must first enter a name and title on the Identification tab before you can run the result settings.
To configure report settings, complete the following steps.
1. Select Reports > Event Custom Reports.
The Event Custom Reports dialog box displays.
2. Click the Add button.
3. The Add/Edit Report Definition dialog box - Product tab, shown in Figure 761 , displays.
4. Click the Result Settings tab.
The Add/Edit Report Definition dialog box - Result Settings tab displays.
FIGURE 761 Add/Edit Report Definition dialog box - Result Settings tab