Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1158)

Brocade Network Advisor SAN + IP User Manual 1105
53-1002949-01
QoS SID/DID priorities over an FCIP trunk
27
FIGURE 465 TCP connections for handling QoS SID/DID-based FC traffic prioritization
Configuring QoS Priorities
For 8 Gbps platforms only, you can change QoS priorities from the default settings using the
following steps:
1. Select Configure > FCIP Tunnels.
The FCIP Tunnels dialog box is displayed. All discovered fabrics with Extension Switches are
listed under devices, and all existing FCIP tunnels are displayed.
2. Select the switch you want to configure under Products.
3. Click the Add button, or right-click on the switch and select Add Tunnel.
The Add FCIP Tunnel dialog box is displayed.
4. Click Advanced Settings.
Virtual
Tunnel
Tunnel
VE Port Internal Architecture
External User Perspective
Circuit
GE Port
High Priority Med. Priority Low Priority F-Class
Virtual
Tunnel
Virtual
Tunnel
Virtual
Tunnel
Virtual
Circuit Virtual
Circuit Virtual
Circuit Virtual
Circuit
TCP
Connection
IP
Interface
TCP
Connection
TCP
Connection
TCP
Connection