Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 174)

Brocade Network Advisor SAN + IP User Manual 107
53-1002949-01
IP discovery profiles
4
Excluding subnet addresses
To exclude subnet addresses (IPv4 only), complete the following steps.
1. Select Subnet from the Entry Type list.
FIGURE 30 Exclude Subnet
2. Enter the IP address in the IP Address field.
3. Enter the subnet mask in the Subnet Mask field.
4. To include an address range using the Subnet format, refer to “Adding subnet addresses” on
page 105.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 104.
Excluding IP addresses
NOTE
To exclude a VCS fabric, you must add all members of the VCS fabric to the exclude list.
To exclude an IP address range (IPv4 and IPv6), complete the following steps.
1. Select IP Address from the Entry Type list.
FIGURE 31 Exclude Address Range
2. Enter the first IP address in the range in the first IP Address field.
3. Enter the last IP address in the range in the second IP Address field.
4. To include an address range using the Address Range format, refer to “Adding IP addresses”
on page 106.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 104.