Tape pools tab – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 1093
Brocade Network Advisor SAN + IP User Manual
1039
53-1002949-01
Viewing and editing encryption group properties
25
FIGURE 453
Encryption Group Properties dialog box - Link Keys tab
Tape Pools tab
Tape pools are managed from the Tape Pools tab. From the Tape Pools tab, you can add, modify,
and remove tape pools.
•
To add a tape pool, click Add, then complete the Add Tape Pool dialog box.
•
To remove an encryption switch or engine from a tape pool, select one or more tape pools
listed in the table, then click Remove.
•
To modify a tape pool, you must remove the entry, then add a new tape pool.
The Tape Pools tab is viewed from the Encryption Group Properties dialog box. (Refer to
Figure 454
.) To access the Tape Pools tab, select a group from the Encryption Center Devices table,
then select Group > Tape Pools from the menu task bar. The Properties dialog box displays with the
Tape Pools tab selected.
NOTE
You can also select a group from the Encryption Center Devices table, then click the Properties icon.