Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1663)

Brocade Network Advisor SAN + IP User Manual 1617
53-1002949-01
Accessing Flow Vision from other management application features
44
Trace route and ping
Select an row from the Forward Route, Reverse Route, and FC Ping tabs on the Trace Route
Summary dialog box and select Add Flow to launch the Add Flow Definition dialog box. Use the Add
Flow Definition dialog box to configure and monitor flows established by your selections on the
Trace Route Summary dialog box. For more information on accessing and using trace route and
ping on the Trace Route Summary dialog box, refer to
“Tracing FC routes” on page 1446.
If rows are not selected on the Trace Route Summary dialog box, the Add Flow Definition dialog box
is populated with the following information when available:
• Source Device - Source ID for ingress port
• Destination Device - Destination ID for egress port
• Target Switch - Switch for ingress port
• Direction - Bidirectional
If you select a row on the FC Ping tab the Add Flow Definition dialog box is populated with the
following information when available:
• Source Device - Source ID
• Destination Device - Destination ID
• Target Switch - Switch for source WWN
• Direction - Bidirectional
Table 160 describes how options are populated on the Add Flow Definition dialog box are
populated according to the row selected on the Forward Route tab.
TABLE 160 Add Flow Definition dialog box options populated per Forward Route row selection
Row Selected Options populated
No rows
selected Source Device = Source ID from source device port
Destination Device = Destination ID from destination device port.
Target Switch = Switch in selected row.
Direction = Bidirectional
If first row is
selected (where
In Port Address
is source device
port's connected
switch port
address) Source Device = Source ID of source device port
Destination Device = * if port is on a 16-Gbps switch, otherwise empty.
Ingress Port = ‘In’ port slot/port of selected row.
Target Switch = Switch of selected row.
Direction = Bidirectional
If last row is
selected (where
Out Port Address
is destination
device port’s
connected
switch port
address) Source Device = * if port is on a 16-Gbps switch, otherwise empty.
Destination Device = * if port is on a 16-Gbps switch, otherwise empty.
Ingress Port = ‘In’ port slot/port of selected row.
Target Switch = Switch of selected row.
Direction = Bidirectional