Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 316)

Brocade Network Advisor SAN + IP User Manual 251
53-1002949-01
Areas of responsibility
7
Creating an AOR
When creating an AOR, you assign devices or groups to that AOR. After you save the AOR, it can be
assigned to one or more user account. Users of those accounts can then view the devices or
groups in their assigned AOR. Users can deploy configurations and payloads only to devices in
assigned AORs.
When you create an AOR, it immediately becomes available in the Users dialog box.
To create an AOR, complete the following steps.
1. Select Server > Users.
The Users dialog box displays.
2. Click Add under the AOR table.
The Add AOR dialog box displays.
FIGURE 92 Users dialog box - Users tab
3. Enter a name of the AOR in the Name field.
4. (Optional) Enter a short description for the AOR in the Description field.
5. Assign or remove products as needed.
For step-by-step instructions, refer to “Assigning products to an AOR” on page 253 or
“Removing products from an AOR” on page 254.
6. Click OK to save the new AOR and close the Add AOR dialog box.
The new AOR displays in the AOR list of the Users dialog box.
7. Click Close to close the Users dialog box.