Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 862)

806 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Layer 3 access control list policy
22
4. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to “Configuring L3 ACL advanced
settings” on page 789.
Service group configuration
The Management application allows you to filter traffic from a specific service group. A service
group is made up of one or more port ranges, services, or service groups. Use the following
procedures to configure a service group:
• “Viewing existing service groups” on page 806
• “Creating a service group” on page 807
• “Editing a service group” on page 808
• “Copying a service group” on page 809
• “Deleting a service group” on page 810
Viewing existing service groups
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an extended L3 ACL configuration” on page 779
• “Copying an extended L3 ACL configuration” on page 780
• “Creating an extended L3 ACL configuration” on page 777
• “Editing an IPv6 L3 ACL configuration” on page 783
• “Copying an IPv6 L3 ACL configuration” on page 784
To view all existing service groups, complete the following steps.
1. Click the Service Groups tab.
FIGURE 287 Service dialog box, Service Group tab