Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1363)

1314 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Spanning Tree Protocol configuration
36
FIGURE 561 STP Configuration dialog box
3. Select the target switch, VLAN, or port from the Target Context list. Target contexts and
spanning tree options at the product, VLAN, or port level are listed in Table 135 .
4. Select the type of spanning tree protocol from the Spanning Tree list.
5. Select the Enable check box if you want to enable the protocol you selected.
6. Enter a value in the Priority field to identify the root bridge in a spanning tree (instance of STP).
The bridge with the lowest value has the highest priority and is the root. A higher numerical
value means a lower priority; thus, the highest priority is 0. The values range from 0 through
61440 for a Fabric OS device; the default is 32768. The values range from 0 through 65535
for an IronWare device; the default is 32768.
7. Enter the number of seconds a bridge waits (the listen and learn period) before it begins to
forward data packets in the Forward Delay field. The values range from 4 through 30 seconds.
The default is 15 seconds.
8. Enter the number of seconds a root bridge waits before it sends the next BPDU in the Hello
Time field. The values range from 1 through 10 seconds. The default is 2 seconds.
9. Enter the number of seconds a bridge waits for a hello packet from the root bridge before
initiating a topology change in the Max Age field. The values range from 6 through 40 seconds.
The default is 20 seconds.
TABLE 135 Spanning tree configuration matrix
Target context STP type
IOS VLAN STP, RSTP
IOS Port STP, RSTP
FOS Product STP, RSTP, MSTP
FOS VLAN MSTP
FOS Port STP, RSTP, MSTP
NOS Product STP, RSTP, MSTP, PVST, and RPVST
NOS VLAN MSTP
NOS Port STP, RSTP, MSTP, PVST, and RPVST