Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 947)

Brocade Network Advisor SAN + IP User Manual 893
53-1002949-01
Steps for connecting to a TEKA appliance
25
Setting up TEKA network connections
Communicating to TEKA is enabled over an SSL connection. Two IP addresses are needed. One
IP address is used for the management interface, and a second IP address is used for
communication with clients. These IP addresses are typically assigned during the initial setup of
the TEKA appliance.
1. Log in to the Thales management program as admin and select the Network tab. (Refer to
Figure 318 .)
FIGURE 318 TEKA Network Settings
2. Enter the management IP address information under Management Interface.
3. Enter the client IP address information under KM Server Interface.
4. Enter a host name for the appliance, Internet or intranet domain, and, if used, the primary and
secondary DNS IP address under Common Settings.
5. Set Service Settings.
- HTTPS Port 433
- SSH Port 22
- Enable SSH
- KM Server Port 9000
- Enable KM Server