Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1746)

Brocade Network Advisor SAN + IP User Manual 1703
53-1002949-01
Viewing a policy monitor report
47

Check the number of initiator ports zoned to each storage port is less than
Configured_Value. This check provides the following additional detail for this check:
- Storage Port — WWN of the storage port.
- Initiator Count — Number of initiator ports zoned to the storage port.
- Initiator Port — WWN of the initiator port.
- Zone — Zone name containing the initiator/storage port zoning pair.

Check zones that do not contain any online member. This check lists the zones that
contain only offline members.

Ethernet Fabric — Checks that all profiles are the same on each RBridge in an
Ethernet fabric. This check provides the following additional detail for this check:
- Profile — Name of the profile.
- Status — Whether the profile matched (Passed) or did not match (Failed).
- RBridge ID (Matching Sets) — Number of matching or missing sets. For example,
(Missing: 73) (Matching: 2).
Switch Checks — Switch checks provide the following information for each selected check:

Name — Product name.

Status — Result of the check and reason for failure if known. Valid results include
Passed, Partially Failed, Failed, Not Applicable, and Unknown.
Switch Checks include the following options:

Switch — Check for at least Configured_Minimum_Value connections to neighboring
switches. This check provides the following additional detail for this check:
- Neighboring Switch — Name of the neighboring switch.
- Connection Count — Number of connections to the neighboring switch.

Switch — Check for HTTPS (secure HTTP) configuration. This check provides the
following additional detail for this check:
- HTTPs Status — Whether HTTPS is enabled or disabled on the product.
- HTTP Status — Whether HTTP is enabled or disabled on the product.

Switch — Check if the product is configured to send events to this server.

Switch — Check if the product is configured to send Upload Failure Data Capture to an
FTP server.

Switch - Check for SSH (secure Telnet) configuration.This check provides the following
additional detail for this check:
- SSH Status — Whether SSH is enabled or disabled on the product.
- Telnet Status — Whether Telnet is enabled or disabled on the product.

Switch - Check for SNMPv3 (secure SNMP) configuration. This check provides the
following additional detail for this check:
- SNMPv3 Status — Whether SNMPv3 is enabled or disabled on the product.
- SNMP Status — Whether SNMP is enabled or disabled on the product.

Switch - Check for VLAN configurations match for each connection (IP only). This check
provides the following additional detail for this check:
- Local Switch Port — Name of the local switch port.
- Local VLANs — Local VLAN number