Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 737)

680 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
DCB configuration
20
DCB configuration
To launch the DCB Configuration dialog box, select Configure > DCB from the menu bar.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
NOTE
For FOS DCB devices, the Protocol Down Reason column, shown in Figure 239 , displays the values
only for the external ports of embedded platforms but not for the internal ports.
FIGURE 239 DCB Configuration dialog box
Minimum DCB configuration for FCoE traffic
You must complete the following procedures to create the basic configuration of DCB for FCoE
traffic.
NOTE
This section is applicable for Fabric OS versions 6.3.0, 6.3.1, 6.3.2, 6.4.1, and 6.4.2. This section is
not applicable for Fabric OS versions 6.3.1_dcb, 6.3.1_cee, 6.4.1_fcoe, and 7.0.x.
In release 12.1 of the Management application, you cannot perform DCB configuration on Network
OS VDX switches. You can only view Network OS switch configuration in the Management
application DCB dialog. Refer to
“Network OS switches in VCS mode” on page 717 for more
information.
NOTE
Editable operations from the Management application on Network OS products are not supported
for this release. You must use the command line interface to configure or modify parameter on
Network OS products. For more information, refer to the Network OS Command Reference.
Beginning with Network OS 4.0, VCS mode encompasses two mode types:
• Fabric cluster mode—The data path for nodes is distributed, but the configuration path is not
distributed. Each node keeps its configuration database independently.
• Logical chassis cluster mode—Both the data and configuration paths are distributed. The
entire cluster can be configured from the principal node. Logical chassis mode requires
Network OS 4.0 or later.