Creating a service group – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 863
Brocade Network Advisor SAN + IP User Manual
807
53-1002949-01
Layer 3 access control list policy
22
2. Review the List of Service Groups table:
•
Name — The service group name.
•
Port Range — The range (1 — 65535) of port numbers.
•
Services — The name of each service in the service group.
•
Service Groups — The name of each service group in the service group.
3. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to
Creating a service group
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
•
“Creating an extended L3 ACL configuration”
•
“Editing an extended L3 ACL configuration”
•
“Copying an extended L3 ACL configuration”
•
“Creating an extended L3 ACL configuration”
•
“Editing an IPv6 L3 ACL configuration”
•
“Copying an IPv6 L3 ACL configuration”
To create a service group, complete the following steps.
1. Click the Service Groups tab.
2. Click Add.
The Add Service Group dialog box displays.
FIGURE 288
Add Service Group dialog box
3. Enter a name for the service group in the Name field.
4. To enter a range of ports, complete the following steps.