Ip preferences, Preferences – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual

Page 275

Brocade Network Advisor SAN + IP User Manual

209

53-1002949-01

Software Configuration

3. Choose one of the following options in the Server IP Configuration list.

•

Select All. Go to

step 4

•

Select a specific IP address. Continue with

step 5

•

Select localhost. Continue with

step 5

4. Select the return IP address in the Client - Server IP Configuration Return Address list.

When Server IP Configuration is set to All, you can select any available IP address as the
Return Address. If you select a specific IP address, the Return Address field shows the same IP
address and you cannot change it.

5. Click Apply or OK to save your work.

NOTE

Changes take effect after you restart the Management Server.

NOTE

You can only restart the server using the Server Management Console (Start > Programs >
Management_Application_Name 12.X.X > Server Management Console).

6. Click OK on the “changes take effect after “application restart” message.

IP preferences

You can configure the following preferences for IP products.

•

Configuring change manager preferences . . . . . . . . . . . . . . . . . . . . . . . . . 210

•

Configuring custom report preferences . . . . . . . . . . . . . . . . . . . . . . . . . . . . 211

•

Configuring deployment preferences . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 211

•

Configuring deployment report preferences . . . . . . . . . . . . . . . . . . . . . . . . 211

•