Deleting a policy or rule, Deploying a pbr policy on demand, Deploying – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 802: A pbr policy on demand
Brocade Network Advisor SAN + IP User Manual
745
53-1002949-01
Policy-based routing
21
3. To edit the rule to the policy, refer to
4. Click OK on the Edit Rule - Policy_Name dialog box.
5. Click OK on the Product_Name PBR Configuration dialog box.
The Deploy to Products - PBR dialog box displays. To deploy the PBR policy, refer to
“Saving a PBR policy deployment”
on page 746, or
“Scheduling a PBR policy deployment”
Deleting a policy or rule
1. Select an Ethernet router, Ethernet core router, or Ehternet Backbone router product and select
Configure > Policy Based Routing.
The Product_Name PBR Configuration dialog box displays.
2. Select the policy or rule you want to delete in the Policy and Rules table and click Delete.
A confirmation message displays. Click Yes to delete the selected rule or the selected policy
and all associated rules.
3. Click OK on the Product_Name PBR Configuration dialog box.
The Deploy to Products - PBR dialog box displays. To deploy the PBR policy, refer to
“Saving a PBR policy deployment”
on page 746, or
“Scheduling a PBR policy deployment”
Deploying a PBR policy on demand
To deploy a PBR policy immediately, complete the following steps.
1. Choose one of the following options:
•
Deploy now — Select to deploy the configuration immediately on the product or port
without saving the deployment definition.
•
Save and deploy now — Select to deploy the configuration immediately on the product or
port and save the deployment definition for future deployment.
2. Select one of the following save configuration options:
•
Save to running — Select to update the running configuration; however, the deployment is
not saved to the product’s flash memory.
•
Save to running and startup — Select to update the running configuration as well as save
the deployment configuration to the product’s flash memory. Selecting this option is the
equivalent to a write memory command on the product CLI.
•
Save to running and startup then reboot — Select to update the running configuration,
save the deployment configuration to the product’s flash memory, and reboot the product.
Selecting this option is the equivalent to entering a write memory and a reload command
on the product CLI.
3. Enter a name for the deployment in the Name field.
4. Enter a description for the deployment in the Description field.