Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1022)

968 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
High availability clusters
25
3. Click the right arrow to add the encryption engine to the selected HA cluster.
4. Click OK.
Removing engines from an HA cluster
Removing the last engine from an HA cluster also removes the HA cluster.
If only one engine is removed from a two-engine cluster, you must either add another engine to the
cluster, or remove the other engine.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 303 on page 852.)
2. Select an encryption group from the Encryption Center Devices table, then select Group >
HA Cluster from the menu task bar.
The Encryption Group Properties dialog box displays, with the HA Clusters tab selected.
3. Select an engine from the High Availability Clusters table, then click the left arrow. (Refer to
Figure 403 .)
4. Either remove the second engine or add a replacement second engine, making sure all HA
clusters have exactly two engines.
5. Click OK.
Swapping engines in an HA cluster
Swapping engines is useful when replacing hardware. Swapping engines is different from removing
an engine and adding another because when you swap engines, the configured targets on the
former HA cluster member are moved to the new HA cluster member.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box.
2. Select an encryption group from the Encryption Center Devices table, then select Group >
HA Cluster from the menu task bar
The Encryption Group Properties dialog box displays, with the HA Clusters tab selected. (Refer
to
Figure 403 .)
To swap engines, select one engine from the High Availability Clusters table and one unclustered
engine from encryption engine from the Non HA Encryption Engines table, then click the dual
arrow.
NOTE
The two engines being swapped must be in the same fabric.